Diagonal Link Bar locator can be used with a 4 link or ladder bar set-up.Kit includes: Threaded locator Bar, Two rod ends, and two bolt in Mounts and bolts.EASY TO INSTALL AND A GREAT VALUE FOR YOUR STREET/HOT ROD! Kit Includes: Coil over Shocks, QA-1 Spring(rate 110,130,150,170, or 200 lbs.)Threaded 4 Link tubes,1″ diameter,.156 DOM tubing, Housing Brackets, Frame Brackets, Adjustable lower shock mounts. Kit Includes: 4 Link Bar, QA-1 Coil Over shock(ranges from 95-225 lbs), Standard 2″ x 3″ cross member with drive shaft hoop, Frame Brackets, Rear end Bracket, Threaded Bars, QA-1 XM rod ends with Teflon/Kevlar races and increases cross-sectional thickness for greater strength and bolts. QA-1 XM rod ends with teflon/Kevlar races and increases cross-sectional thickness for greater strength, Diagonal link with bolt in bracket and rod ends. call me 502-314-3984 or 502-447-4881 67-69 CAMARO 4-BAR KIT. THIS KIT WILL ALLOW YOU TO USE YOUR STOCK LEAF SUSPENSION WITH THE ABILITY TO RUN A BIGGER TIRE WITH OUT CUTTING OUT YOUR BACK SEAT. Kit comes with 2×3 mandrel bent rails, completley jig welded with Ladder Bar mounts and upper shock cross member fully installed.
THIS KIT IS FULLY ASSSEMBLED AND READY TO WELD INTO CAR AS SHOWN IN THE PICTURE. Great for Pro Street, Street Rods, Entry level Brakcet Race Cars. (available in 9 inch ford, Dana,or Chevy, 4 link or ladder bar brackets add .00.) Add 0.00 for back brace. Any additional race car product visit our ebay store or give me a call. THESE ALUMINUM SHOCKS FEATURE A 5/8 HARD CHROME PISTON ROD WITH A VALVING SYSTEM THAT ADJUST TO ROAD DEMANDS. QA1 springs are dyno tested to insure each spring is within 5% of it advertised rate. Qa1 Spring is made with silicone/vanaduim spring wire available. QA1 springs are dyno tested to insure each spring is within 5% of it advertised rate. Shock only(1) $ 170.00 plus shipping A Pair of Shocks(2) 0.00 plus shipping. $ 450.00 Also available in 28,30,31,33,& 35-Spline. GREAT FOR A FULL FRAME CHASSIS FOR PRO STREET, STREET RODDER, DRAG RACE. GREAT FOR A FULL FRAME CHASSIS FOR DRAG RACING OR STREET RODDER. THIS FRONT END WILL REPLACE YOUR STOCK FRONT END AND LOSE UP TO 200 LBS.